SAGA may be a skirmish game, but moving multiple miniatures
en masse on the battlefield can be tedious, so I decided to buy some of these excellent 2p Sabot skirmish bases from Warbases.
Here's how I did them:
1. Apply texturing.
I use
GOLDEN coarse pumice gel, this allows me to make an uneven surface, but allows me to apply ink directly to it once dry. I use a knife to apply the gel, scraping away any that falls inside the sabots.
2. Whilst the gel is drying, I apply various tufts in random locations. I use tweezers to remove the tufts from the backing and to press directly onto the surface.
3. Once the gel is dry, I apply a brown ink wash
Again, you should try to avoid inking inside the sabots, as the ink will become the glue for flock. Make sure you get the brown as close to the roots of your tufts as possible.
 |
| Fully inked and ready for dipping. |
4. Whilst the ink is still wet, dip in your dipping tray. Here's mine, made of normal flock, clump flock and scenic leaves.
I bought the leaves from
Atenociti's workshop. Far more than I'll ever need for a reasonable price. My friend bought the dead leaves, so we traded a small amount (in the bag).
So, pop your still-wet base in there
Then give the whole box a few shakes to randomly cover the wet bits
 |
| Yes, the base is in there. |
Pull it out, shake it off and voila.
You'll notice there are some brown bits, which is fine. After dipping, run around the edge of the base with your finger to clear unwanted flock. You may want to take any detritus from inside the sabots out with a knife edge too.
This process works on larger bases in the same way, but you may need to dip each edge separately and sprinkle some across the middle.
 |
| before |
 |
| after |
So, pretty easy to do. Here's how they all look. Finished units at the back, newer, unfinished to the right, and the empty ones are for the two units I need to make for my basic 6pt army.
 |
| The army so far |
Expect finished Priodaur unit 2 in WIP #7.
No comments:
Post a Comment